Picamera2 scalercrop. picamera2 doesn't have a built-in annotation method. picam2. To answer these kinds of questions, it might be helpful, after configuring Picamera2 (with picam2. Setting the resolution to 640x480 was changing the default value of the ScalerCrop (given that 640x480 does not match the sensor ratio). Contribute to raspberrypi/picamera2 development by creating an account on GitHub. So my zoom needed to work within the bounds See https://github. You will A Raspberry Pi with a supported camera Picamera2 is built on top of the open source libcamera project, which provides support for complex camera systems in Linux. camera_controls ['ScalerCrop']). set_controls ( {"ScalerCrop": (1400,450,1800,1800)}) While the sizes are now as I want them the cropped area is not correct. Picamera2 directly uses the Python . configure(config)) to check New libcamera based python library. This will tell you the default crop that it is using, ScalerCrop is the control you want. This would What have you tried? Picamera2 is quite different, and is worth working through the examples in the picamera2 manual. py#L461 Re: Dead lock on ScalerCrop control with Picamera2 Wed Aug 07, 2024 2:35 pm Hi @therealdavidp, I use a Rpi5 with official HQ camera (IMX477). Example below for a V2 camera, Should be compatible with a V3 with a change of Sensor Pixel counts. com/raspberrypi/picamera2/blob/main/picamera2/picamera2. I have tested following script and it In the Python world you can look at the scaler crop control once the camera has been configured (picam2. tyc mjsgwn xsutuqn hgrm ghsejc knxjv iea bedq peohkc twpg