Qnap Bond0, This is not a real Hello, i recently upgraded my DS918+ with QNAP QNA-UC5G1T adapter witch can deliver 5gbps lan speed. 901 is a virtual device allowing for a tagged vlan 901 on bond0. Over time I had many tickets opened to get QNAP to fix using the bond0 network. For the balance-rr, balance-xor, broadcast, and 802. Even though the NAS supports bond0 setup, doesnt seem like all the apps make use of it correctly. My wire connectivity is not stable thus Wi-Fi should act as a backup. 901 VLAN 901 interface. , bond0), and propagates the setting to the slave devices. 901:1 is just an secondary IP address for the bond0. I want to use the network interfaces The bonding driver handles promiscuous mode changes to the bonding master device (e. The bond0. g. Followed instructions from here : DSM driver for Aquantia AQC111U (5Gbps) I bought a Wi-Fi card for my NAS TVS-472XT as a backup network link. 3ad If you have link aggregation enabled on your QNap NAS, then your docker network create command should use bond0 instead of eth0. ac1lpkhss7r34f2bm9dgbmjugqv6rohjwtwr8earwujs18